Madhav Industries builds, repairs and rebuilds hydraulic cylinders and power packs on our own CNC lathes and honing equipment — from a single-acting jack to a 200mm-bore excavator arm cylinder.
From a single replacement cylinder to a full power pack, built on our own equipment — not subcontracted out.
Single and double acting cylinders, 3 to 50 ton capacity, custom bore and stroke.
View rangeFull strip, re-bore, hone and reseal — including slide gate and excavator cylinders.
View rangeCompact power units built and tested to run your cylinder from a single supply.
View rangeExcavator and mining-duty cylinders built for abrasive, high-load environments.
View rangePress cylinders and jacks built to fit an existing frame with no rework needed.
View rangeDescribe the machine and the failure — we'll tell you honestly what it needs.
Get in touchReal CNC turning, not a stock photo — this is what runs behind every cylinder we build.
Bore, stroke, mounting and pressure rating confirmed.
Barrel and rod turned on CNC lathe to spec.
Barrel bored and honed to precise tolerance.
Seal kit fitted, piston and rod assembled.
Tested under load before it leaves the shop.
Shipped by road with test certificate.
Our press cylinder failed mid-shift. Madhav had a rebuilt unit turning on the lathe within hours and reinstalled the same day — not a week of downtime.
Bore, stroke, mounting type and the failure you're seeing — we'll quote honestly on cost and turnaround.